APM

Product parameters: Wheelbase: 95mm (2inch) Empty weight（Including 3D printed parts）: Approximately 70g Weight of the whole machine (excluding battery)：165g Thickness:

ParameterProduct Name: B-CUBE 20MM-50AInput Voltage: 2-6S LiPoOutput Current: 50A4 BEC: No Current Meter: Yes Mounting: 20mm20mm / M3Dimensions: 29mm*32mmFirmware: BlueJay

AM32-45A ESC Hardware: AM32-MultiRotor-ESC Firmware Firmware for ARM based speed controllersThe AM32 firmware is designed for STM32 ARM processors to

Attention: The VTX800 supports up to 1600MW, and it is recommended to set it to 800MW when used for a

B-CUBE F745 V2 Flight Controller If you have any questions, please post a topic on the forum. We have 20

F4DC Flight Control 1.We had upload the Betaflight / STM32F411 (S411) 4.2.0 firmware and config it ,you can use it directly

Thank you for purchasing BLHeli ESC, please read this manual carefully before you use the ESC and strictly follow the

Some people maybe meet this problem using APM flight controller. How to solve it? APM cannot use “Install Firmware”.Should use

some people want to modify the the parameters of radio telemetry , but many people do wrong.It is not recommended

1.install the Mission planner, you can download from here, https://firmware.ap.ardupilot.org/Tools/MissionPlanner/archive/MissionPlanner-1.3.74.msi 2.select the right COM port and 115200 baud rate. NOTE:

Bootloader for APM2.x autopilot series Bootloader for: 32u2 MCU Bootloader for: 2560 MCU You need AVR programmer with ISP connector to burn

APM2.9 is used in the same way as APM2.6, 2.8. The benefit is that APM 2.9 supportsSBUS receiver protocols.Why use

APM2.9 is used in the same way as APM2.6, 2.8. The benefit is that APM 2.9 supports SBUS receiver protocols.Why

APM2.9 is used in the same way as APM2.6, 2.8. The benefit is that APM 2.9 supports PPM receiver protocols.Why

APM2.9 is used in the same way as APM2.6, 2.8，the hardware is same. The benefit is that APM 2.9 supports

APM2.9 is used in the same way as APM2.6, 2.8. The benefit is that APM 2.9 supports PPM receiver protocols.Why

The apm connects to PC, make sure you have installed the Misson Planner, and select the right port and baud

Now the latest Mission planner incompatible with APM2.8 ,it can not calibrate Accel for APM,please use version 1.3.74. Download Mission