B-CUBE AM32-45A ESC
AM32-45A ESC Hardware:
- ESC Firmware: AM32_NEUTRON_G071_1.91.hex
- Processor: 32-bit ARM Cortex STM32G071GBU6TR, frequency up to 64 MHz
- PWM carrier frequency: 48kHz
- ESC protocol: PWM/DShot300/DShot600 (Recommended to use DShot300)
- Power input support: 3-6S (11.1V-27V)
- Maximum continuous operating current: 45A (requires adequate heat dissipation and cannot operate in a sealed environment)
- MOSFET Parameters: 40V 0.75mΩ Ultra-Low On-Resistance
- Galvanometer output: 12.75 mV/A
- Weight: 14g
- Board size: 35MM * 18MM
- Recommended Usage Scenario: 3.5-10 inch FPV Racing Drone
AM32-MultiRotor-ESC Firmware
Firmware for ARM based speed controllers
The AM32 firmware is designed for STM32 ARM processors to control a brushless motor (BLDC). The firmware is intended to be safe and fast with smooth fast startups and linear throttle. It is meant for use with multiple vehicle types and a flight controller. The firmware can also be built with support for crawlers. For crawler usage please read this wiki page Crawler Hardware
Features
AM32 has the following features:
- Firmware upgradable via betaflight passthrough, single wire serial or arduino
- Servo PWM, Dshot(300, 600) motor protocol support,Recommended to use Dshot300
- Bi-directional Dshot
- KISS standard ESC telemetry
- Variable PWM frequency
- Sinusoidal startup mode, which is designed to get larger motors up to speed